Restriction Enzymes SalI

A restriction enzyme or restriction endonuclease is defined as a protein that recognizes a specific, short nucleotide sequence and cuts the DNA only at or near that site, known as restriction site or target sequence. The four most common types of restriction enzymes include: Type I (cleaves at sites remote from a recognition site), Type II (cleaves within or at short specific distances from a recognition site), Type III (cleave at sites a short distance from a recognition site), and Type IV (targets modified DNA- methylated, hydroxymethylated and glucosyl-hydroxymethylated DNA). The most common challenges with restriction digest include- 1. inactivation of the enzyme, 2. incomplete or no digestion, and 3. unexpected cleavage. The enzyme should always be stored at -20C and multiple freeze-thaw cycles should be avoided in order to maintain optimal activity. Always use a control DNA digestion with the enzyme to ensure adequate activity (to avoid interference due to high glycerol in the enzyme). For complete digestion, make sure that the enzyme volume is 1/10th of the total reaction volume, the optimal temperature is constantly maintained throughout the reaction, the total reaction time is appropriately calculated based on the amount of DNA to be digested, appropriate buffers should be used to ensure maximal enzymatic activity, and in case of a double digest, make sure that the two restriction sites are far enough so that the activity of one enzyme cannot interfere with the activity of the other. Star activity (or off-target cleavage) and incomplete cleavage are potential challenges which may occur due to suboptimal enzymatic conditions or inappropriate enzyme storage. To avoid these, follow the recommended guidelines for storage and reactions, and always check for the efficacy of digestion along with purification of digested products on an agarose gel.

Start discussion

No discussions found

Start your discussion

Share your thoughts or question with experts in your field

Start a discussion

Found 5 matching solutions for this experiment

SalI NEB#R0138

New England BioLabs

Protocol tips
The microsatellite-enriched cDNA PCR products was digested with SalI and NotI using the following protocol: 20 μl (ca. 500 ng) cleaned cDNA, 3 μl 10 × SalI buffer, 1 μl (20 units) SalI (NEB) and 1 μl (10 units) NotI (NEB) at 37°C for 2 hours.
Downstream tips
After digestion, the cDNA was electrophoresed on 1% low melt gel (BIO-RAD). Fragments between 500 bp and 1200 bp were excised and cleaned using glassmilk (Gen 101). Approximately 50 ng cDNA was ligated to 25 ng pCMV-SPORT-6 vector (Invitrogen) which was used to transform XL-blue supercompetent cells (Stratagene). Schematic presentation of the method for microsatellite enrichment from normalized cDNA is shown in Figure ​Figure11.
SalI-HF®

New England BioLabs

Protocol tips
The thereby assembled complementation cassette was gel-purified, verified by sequencing and further cleaved by EagI-HF (NEB) and SalI-HF (NEB) following manual’s instructions. Analogously, respective pENTRY-miniCR-constructs (see above) were cleaved by the same enzymes, respectively, as a EagI and a SalI restriction site are sequentially located 5 bp upstream of the truncated leader promoter (cf. Fig. 2a).
FastDigest SalI

Thermo Fisher Scientific

Protocol tips
The 3 DNA fragments were digested with 4 kinds of FastDigest restriction enzymes (KpnI, HindIII, BamHI, and SalI) in FastDigest Buffer (Thermo Fisher Scientific, Waltham, MA, USA), and ligated to the KpnI-SalI sites of the pUC19 vector (Takara Bio) to yield a plasmid, pAYA1, carrying the ΔrodZ::hph mutation.
SalI R6051

Promega

Protocol tips
The purified PCR products were then digested with NdeI (Promega) and SalI (Promega) at 37°C for 1 h.
Downstream tips
The restriction digests were purified as described above with a Qiagen QIAquick PCR purification kit and eluted in 30 μl ddH2O.
SalI (10 U/µL)

Thermo Fisher Scientific

Protocol tips
This T2A-NeoR fragment was digested with XhoI (Thermo Scientific), HSVtk fragment was digested with SalI (Thermo Scientific), fragments were ligated and the fragment of predicted length was gel purified again.
Can't find the product you've used to perform this experiment? It would be great if you can help us by Adding a product!

Outsource your experiment

Fill out your contact details and receive price quotes in your Inbox

  Outsource experiment
Become shareholder Discussions About us Contact Privacy Terms