siRNA / RNAi /miRNA transfection Human Cells - HT-1376 ROCK2

RNAi or RNA interference is a common method to suppress gene expression in vitro/in vivo by utilizing the inherent microRNA machinery, without introducing a total gene knockout. miRNA is the inherent gene silencing machinery which can have more than one mRNA target, whereas siRNA can be designed to target a particular mRNA target. By design, both siRNA and miRNA are 20-25 nucleotides in length. The target sequence for siRNAs is usually located within the open reading frame, between 50 and 100 nucleotides downstream of the start codon. There are two ways in which cells can be transfected with the desired RNAi: 1. Direct transfection (with calcium phosphate co-precipitation or cationic lipid-mediated transfection using lipofectamine or oligofectamine), and 2. Making RNAi lentiviral constructs (followed by transformation and transduction). Lentiviral constructs are time-consuming, but provide a more permanent expression of RNAi in the cells and consistent gene silencing. Direct transfection of oligonucleotides provides temporary genetic suppression. Traditional methods like calcium phosphate co-precipitation have challenges like low efficiency, poor reproducibility and cell toxicity. Whereas, cationic lipid-based transfection reagents are able to overcome these challenges, along with applicability to a large variety of eukaryotic cell lines.

1 Matching solution
1 Discussion

Found 1 discussion for this experiment

Discussion

5 years ago

5 years ago by Keith L. Morrison Canada

siRNA/RNAi/miRNA transfection human

I would like to regulate the expression of a gene and in order to do that, I have purchased specific siRNA. After optimizing my transfection protocol and using electroporation I have achieved a 60-70% reduction of the gene of interest. However, I cannot observe a significant reduction of mRNA expression but only a reduction of protein. What might be the problem? Could the problem be in my cell treatment method?

Comment View 3 comments

Share your thoughts or question with experts in your field by adding a discussion!

Found 1 matching solution for this experiment

Rock-2 siRNA and shRNA Plasmids (h)

Santa Cruz Biotechnology

Upstream tips	Protocol tips	Downstream tips
	Lipofectamine® 2000 reagent (Invitrogen; Thermo Fisher Scientific, Inc.) was used to perform all cell transfections with 10 nM vectors or 50 nM siRNA and using aforementioned cell lines at a density of 1×106 cells in 2 ml cell suspension. Treatment with Lipofectamine® 2000 reagent alone was used as the C group and transfection with empty vectors or NC siRNA was used as the NC group. Cells were used for subsequent experiments when LINC01638 and ROCK2 overexpression rates were >200% and ROCK2 knockdown rate was <50%, only. The time interval between transfection and subsequent experimentation was 24 h.

Protocol tips
Lipofectamine® 2000 reagent (Invitrogen; Thermo Fisher Scientific, Inc.) was used to perform all cell transfections with 10 nM vectors or 50 nM siRNA and using aforementioned cell lines at a density of 1×106 cells in 2 ml cell suspension. Treatment with Lipofectamine® 2000 reagent alone was used as the C group and transfection with empty vectors or NC siRNA was used as the NC group. Cells were used for subsequent experiments when LINC01638 and ROCK2 overexpression rates were >200% and ROCK2 knockdown rate was <50%, only. The time interval between transfection and subsequent experimentation was 24 h.

Protocol tips

Lipofectamine® 2000 reagent (Invitrogen; Thermo Fisher Scientific, Inc.) was used to perform all cell transfections with 10 nM vectors or 50 nM siRNA and using aforementioned cell lines at a density of 1×106 cells in 2 ml cell suspension. Treatment with Lipofectamine® 2000 reagent alone was used as the C group and transfection with empty vectors or NC siRNA was used as the NC group. Cells were used for subsequent experiments when LINC01638 and ROCK2 overexpression rates were >200% and ROCK2 knockdown rate was <50%, only. The time interval between transfection and subsequent experimentation was 24 h.

Manufacturer protocol Publication protocol 1 Relevant paper

Can't find the product you've used to perform this experiment? It would be great if you can help us by Adding a product!

Outsource your experiment

Fill out your contact details and receive price quotes in your Inbox

Outsource experiment