Eco52I (EagI) (10 U/µL)

Protocol tips

Upstream tips	Protocol tips	Downstream tips
	The purified DNA sample was treated in a 2-step reaction with a set of MREs in cocktail as RE1, including Cfr42I (SacII), PdiI (NaeI), Eco52I (EagI) and PteI (BssHII)(FastDigest enzyme from Thermal Scientific Inc.), called 4E collectively. Step 1 is the treatment with Cfr42I and PdiI in 1 × Tango Buffer at 37°C for 1 h. Step 2 is the treatment with Eco52I and Ptel after adjusting the buffer to 2 × Tango Buffer and incubating at 37° C for 1 h. Afterward, these MREs were heat-deactivated at 70°C for 10 min. The digested DNA sample obtained was immediately amplified using REPLI-g UltraFast Mini Kit (Qiagen) following the manufacturer-recommended protocol except that denature and neutralization steps were skipped.

Protocol tips

The purified DNA sample was treated in a 2-step reaction with a set of MREs in cocktail as RE1, including Cfr42I (SacII), PdiI (NaeI), Eco52I (EagI) and PteI (BssHII)(FastDigest enzyme from Thermal Scientific Inc.), called 4E collectively. Step 1 is the treatment with Cfr42I and PdiI in 1 × Tango Buffer at 37°C for 1 h. Step 2 is the treatment with Eco52I and Ptel after adjusting the buffer to 2 × Tango Buffer and incubating at 37° C for 1 h. Afterward, these MREs were heat-deactivated at 70°C for 10 min. The digested DNA sample obtained was immediately amplified using REPLI-g UltraFast Mini Kit (Qiagen) following the manufacturer-recommended protocol except that denature and neutralization steps were skipped.

Publication protocol

"Cells were suspended and washed twice with phosphorbuffered saline (PBS). Single cells were picked up with a
1–10 ul pipette and dispensed into individual PCR tubes
with each cell transferred with ∼1 l volume of sheath PBS.
Three microliters (3) genomic lysis buffer (Zymo Research)
was then added to each tube and the cell was lysed in 10
min at room temperature. DNA in the lysate was purified
by ethanol precipitation using Dr GenTLE precipitation
carrier (ClonTech). The purified DNA sample was treated
in a 2-step reaction with a set of MREs in cocktail as RE1,
including Cfr42I (SacII), PdiI (NaeI), Eco52I (EagI) and
PteI (BssHII)(FastDigest enzyme from Thermal Scientific
Inc.), called 4E collectively. Step 1 is the treatment with
Cfr42I and PdiI in 1 × Tango Buffer at 37◦C for 1 h. Step
2 is the treatment with Eco52I and Ptel after adjusting
the buffer to 2 × Tango Buffer and incubating at 37◦
C for 1 h. Afterward, these MREs were heat-deactivated
at 70◦C for 10 min. The digested DNA sample obtained
was immediately amplified using REPLI-g UltraFast Mini
Kit (Qiagen) following the manufacturer-recommended
protocol except that denature and neutralization steps
were skipped. The amplicons were combined with negative
controls (no cells but PBS only), which did not show any
visible band on electrophoresis gel. The amplified DNA
was purified using genomic DNA clean & concentrator kit
(Zymo Research). Usually approximately 3–4 g of DNA
amplicon was obtained, sufficient for PCR evaluation and
library construction. This above was for the TEST sample.
The control DNA (MC) was conducted through the same
process except that no RE1 digestion steps were applied."

Full paper   Login or join for free to view the full paper.

Reviews

Discussion

Papers

Check out relevant papers found by Labettor's AI that are relevant for performing Restriction Enzymes Eco52I / EagI using Eco52I (EagI) (10 U/µL) from Thermo Fisher Scientific.

Manufacturer protocol

Download the product protocol from Thermo Fisher Scientific for Eco52I (EagI) (10 U/µL) below.

Download manufacturer protocol

Videos

Check out videos that might be relevant for performing Restriction Enzymes Eco52I / EagI using Eco52I (EagI) (10 U/µL) from Thermo Fisher Scientific. Please note that these videos are representative and steps or experiment specific processes must be kept in mind to expect desired results.