Protein expression and purification Insect cells S2

Get tips on using VWR Life Science RIPA Lysis Buffer, Biotechnology Grade to perform Protein isolation Mammalian cells - Caco-2

Get tips on using Enzo BioArray™ Single-Round RNA Amplification and Biotin Labeling System to perform Microarray RNA amplification & Labeling - Rhesus monkey brain tissue Biotin

DNA-protein interactions are studied by using ChIP. The basic steps in this technique are crosslinking, sonication, immunoprecipitation, and analysis of the immunoprecipitated DNA. During ChIP, if chromatin is under-fragmented or fragments are too large which can lead to the increased background and lower resolution. Shorter cross-linking times (5-10 min) and/or lower formaldehyde concentrations (<1%) may improve shearing efficiency. If Chromatin is over-fragmented, then optimize shearing conditions for each cell type to improve ChIP efficiency. Over-sonication of chromatin may disrupt chromatin integrity and denature antibody epitopes. If you do not see any product or very little product in the input PCR reactions, add 5–10 μg chromatin per IP.

Get tips on using IMAGEN™ Influenza Virus A and B Kit using Direct Immunofluorescence Assay to perform Cell Culture Contamination Detection Kit Virus

Get tips on using Enzo BioArray™ Single-Round RNA Amplification and Biotin Labeling System to perform Microarray Rhesus monkey - Brain tissue Target preparation (RNA amplification + labeling)

Get tips on using Enzo BioArray™ Single-Round RNA Amplification and Biotin Labeling System to perform RNA amplification & labeling Mammalian - RNA, rhesus monkey brain tissue Biotin

Get tips on using mirVana™ miRNA Isolation Kit, with phenol to perform RNA isolation / purification Cells - primary human pulmonary artery smooth muscle cells

Get tips on using VWR Life Science RiboZol™ RNA Extraction Reagent to perform RNA isolation / purification Cells - primary rat brain microvascular endothelial cells

miRNA is the inherent gene silencing machinery which can have more than one mRNA target, whereas siRNA can be designed to target a particular mRNA target. By design, both siRNA and miRNA are 20-25 nucleotides in length. The target sequence for siRNAs is usually located within the open reading frame, between 50 and 100 nucleotides downstream of the start codon. There are two ways in which cells can be transfected with desired RNAi: 1. Direct transfection (with calcium phosphate co-precipitation or cationic lipid mediated transfection using lipofectamine or oligofectamine), and 2. Making RNAi lentiviral constructs (followed by transformation and transduction). Lentiviral constructs are time consuming, but provide a more permanent expression of RNAi in the cells, and consistent gene silencing. Direct transfection of oligonucleotides provides temporary genetic suppression. Traditional methods like calcium phosphate co-precipitation have challenges like low efficiency, poor reproducibility and cell toxicity. Whereas, cationic lipid-based transfection reagents are able to overcome these challenges, along with applicability to a large variety of eukaryotic cell lines. When using oligos, the ideal concentration lies between 10-50nM for effective transfection.